Flexiloo Datasheet

Toilet cubicle

Width	Folded 0.9m	Assembled 0.9m
Depth	0.69m	1.8m
Height	2.2m	2.2m
Weight	120kg (approx. depending on model)
Standard toilet fitted	Jets 64FD/VPC
Water consumption (per flush)	0.8 litres
Lighting	1x 13w fluorescent
Power connection	1x system connection in 1x system connection out

Return to top of the page

Urinal unit

Width	Folded 0.655m	Assembled 1.8m
Depth	0.925m	0.9m
Height	2.2m	2.2m
Weight	90kg (approx. depending on model)
Number of urinals	3
Lighting	3x 13w fluorescent
Power connection	1x system connection-in 1xsystem connection-out

Return to top of the page

Vanity unit

Width	0.9m
Depth	0.6m
Height	2.2m
Weight	60kg (approx. depending on model)
Master unit only:
	Automatic infra red tap (depending on model) 2.2kw 240v water heater 240v distribution board with RCD and circuit breakers
Power connection	1 no 16amp 240v in 2x interface unit supplies 2x system connections-out
Lighting	2x 240v 50w halogen
Satellite unit only:
	Automatic infra red tap (depending on model) 2.2kw 240v water heater 240v distribution board with RCD and circuit breakers
Power connection	1x system connection-in 1x system connection out
Lighting	2x 240v 50w halogen
Nb. A maximum of 3 satellite units per master unit. At least one master unit needed for each installation.

Return to top of the page

Vanity system

15MB Pump system (multiples of)	Capacity 15m³/hr Flushing capacity 150 flushes/hr Power cons. (nom) 1.5kW 230v 50Hz Current 6.1A
Weight	70kgs (approx)
Power connection	1x 16a 240v Single phase
Grey water tanks-basins and urinals discharge to tank by gravity and interfaced with vacuum system by ED valve which is activated by water level

Return to top of the page

Flexiloo General Requirements

Introduction

The Flexiloo luxury toilet system is designed to fold for transportation and is fully portable and easily moved and installed by one person using the Flexiloo trolley. It is intended to be installed in covered areas and is not suitable for use outside without suitable protection from weather, eg building, marquee or temporary structure.

There are modules to provide cubicles, urinals and vanity units with accessible modules currently under development. As each module width is based on multiples of 0.9m it is possible to install the modules in any order to provide flexible arrangements for any number of guests or configuration.

Each module is based on a strong, rot free fibreglass sub floor which can be adjusted with shims but it is necessary for the installation site to be firm and fairly level. Panels are a lightweight composite construction with high pressure laminate surfaces for easy cleaning.

The system is primarily designed for use with vacuum drainage with low water usage and no need for chemicals but can be manufactured with a conventional gravity system if required.

System Requirements

Siting:
A firm level base protected from weather. Minimum access width 700mm.

Power:
A basic 3+1 setup will need 1x13amp single phase supply (240v) for the pump assembly (1.5kw) and 1x13amp single phase supply (240v) for water heating and lighting (3kw). Larger installations will require additional supplies depending on total equipment provided.

Water:
One supply normally required @ approximately 3 bar but can be supplied using tanks and booster pump if necessary.

NB. See data sheet for more information.

Return to top of the page